GFI EndPointSecurity, Add, 100-249u, 1Y, ENG Manual Pagina 35

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 156
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 34
GFI EndPointSecurity 3 Achieving Results | 35
3. Configure protection policy settings
Configure the protection policy to block removable storage devices. This prevents end-users from
using devices that allow them to transfer data from and to a computer. Refer to the following
sections for information about:
Configuring controlled device categories
Configuring access permissions for device categories
Configuring access permissions for specific devices
Configuring priorities for permissions
Viewing access permissions
Configuring device blacklist.
4. Configure notification alerts on attempted breach of the security policy
GFI EndPointSecurity can send notifications to a single or group of recipients when an end-user
attempts to breach a security policy. This enables you to immediately take the required actions
and terminate unauthorized use of removable storage devices. Refer to the following sections for
information about:
Configuring alerts
Configuring alerting options
Configuring the alerts administrator account
Configuring alerts recipients
Configuring groups of alert recipients.
5. Configure temporary access for genuine use of removable storage devices
If a blocking protection policy is active, GFI EndPointSecurity still enables you to temporary allow
access to a device to genuinely transfer data to and from a computer. Refer to the following
sections for information about:
How GFI EndPointSecurity works - Temporary Access
Configuring power users
Configuring temporary access privileges
Configuring device whitelist
Configuring user messages.
3.2 Automating network protection
After configuring GFI EndPointSecurity, you can automatically protect new computers that are
detected on reachable networks. This can be achieved by specifying the domain(s) and/or workgroup
(s) that must be scanned for new computers and upon detection of one, GFI EndPointSecurity installs
an agent automatically and assigns it the default policy. Policies can be changed from Configuration
tab > Computers sub-tab.
Vista de pagina 34
1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 155 156

Comentarios a estos manuales

Sin comentarios